Follow These Instructions to Start Up the Virtual Monitor Wall Software

1. Double click on the icon VCC4_7s0.exe from the desktop of the controller



2. The first menu is the Hardware Detection Report. Here you will see all the available Com ports and the module connected to them. Select OK to continue.



3. The second menu you will see is the group setup screen. This will show the group number, the com port being used, and the ID and type of module connected to that com port. If you have only one group, then you will only see this menu once; however if you have multiple groups, this screen will appear for every group you have in your system. Select Set to continue.



4. Since our example system has two groups, we will see a second group setup menu. Select Set to continue.



5. The last menu you will see is the Global Display Settings menu.
Select OK to finish.
Note: If you plan to save presets with different labels, make sure to check Save Label Based on Presets. If you plan to use global labels with all saved presets, leave this box unchecked.



6. After the software goes through and initializes all the modules in your system, you will see the following screen. The first group is highlighted by default and you must select F5 or click on Update to update any changes made on your control display to your group display. Now you can move on and configure your virtual monitor wall system.